Recordum update 2.4.111. release for Q1 2026update 2.4.111.
This release delivers a broad platform and usability update focused on reliability, connectivity, and future-ready instrumentation support:
- Expanded device integration support, including new adapter capabilities and onboarding for additional instruments.
- Improved communication handling across serial/TCP workflows for more robust field connectivity.
- Enhanced web interface behavior and configuration workflows, including improved setup handling for COM/IP-related paths.
- Strengthened operational stability through backend modernization and logging improvements.
- Included targeted security/maintenance updates and general quality improvements across core services.
This update is designed to improve day-to-day stability while preparing Recordum systems for upcoming feature expansion.
I have a question regarding the calibration of Red-Y mass flow controllers (MFCs), employed in Recordum dynamic calibrators, model AirQrate.
For the calibration of high-flow MFCs: should the zero air pump integrated into the equipment be used, or is it necessary to supply zero air from an external generator?
For low-flow MFCs: is it appropriate to use a zero air generator at 25 psi?
Regarding measurement units: should the calibration always be performed in Ln/min throughout the entire procedure, even when the equipment requires entering the flow setpoint in L/min?
Thank you in advance for your attention. I look forward to your response.
Kind regards,
Fabio Figueroa Benítez
Dear Fabio,
the massflows must take out and send to the manufacturer to calibrate.
for more support please open a ticket under the following link:
https://www.airpointer.tech/mlu-recordum-support/?wpsc-section=ticket-list
BR
Fatih Adigüzel